(PRE-ORDER: open through Sunday Nov 1 at 9 PM CT. Ships by Nov 7. Every 5 pens you order, you get a 6th free.)

No tools. No screws. No rigging. Hooks on, locks under the chicken's weight, and lifts out in seconds. An original Beamology design.

Most platform brackets are made to screw into a coop wall. Most gamefowl pens are wire. The WireLock system was designed from the ground up for the same 2"×6" welded wire pens the gamefowl community actually uses.

New design

Heavy roosters don't always jump down. Some slide off the edge, and that slide can work a platform loose. Mk2 adds a new locking-notch at the business end of the bracket, making 100% sure that the only time your platform comes down is if you choose to remove it. Proven on and active within our own yard here at home, like everything we build. 

What you get

• 2 brackets per pen. Pick how many pens above.
• Board not included. Cut your 2x4 to whatever length suits your pen or your needs. (18" recommended/fits on doors)
• Every order ships free. Even our smallest pack clears the free-shipping minimum.

How it works

The bracket hooks over a horizontal wire and its arm braces against the wire spanning 6" above the first. When the bird steps onto the platform, its weight pulls the bracket tighter against the wire in both places, essentially locking it deeper into place. The heavier the load, the tighter it holds.

Why WireLock

• Built for wire pens. Mounts directly to 2"×6" wire mesh with no posts, framing, or ties.
• Pen stays intact. No screws, drilling, or janky rigging needed for the perfect setup.
• Out in seconds. Lift the platform out for feeding, cleaning, or moving birds, then drop it back in.
• Made to live outside. CNC-machined from UV-stabilized PVC, so no rusting, rotting, or corroding.

Specs

• Bracket Dimensions: 7" tall, 9" deep
• Strength: sized for a full-grown rooster landing hard, with a wide safety margin. Your pen wire will bend/give before a WireLock bracket does.
• Material: UV-stabilized PVC

Fit check

Designed for standard 2"×6" welded wire (3.5mm bar). Openings and wire gauge vary by manufacturer, so measure your wire before ordering.

Designed and made by Beamology CNC in Bowling Green, KY. WireLock is our new line of pen hardware for the gamefowl community, and more mounts are coming soon!